Ring Size Guide

Welcome to our sizing guide. Before reading along, please be advised that we use US Standard Ring Sizes in all of our rings.
We also highly recommend visiting a local jewelry shop to have your finger professionally measured. This is because there is a margin of error of at least ±1/4 size in using sizing charts.

  

Here are some common ways to measure your ring size:

Using your Ring

  1. You can use any ring of yours that fits the finger where your DoubleAccent ring will be worn.

  2. Measure the inside diameter in mm or inches by aligning the ring on a ruler. The edge of the inside of the ring should be aligned with 0 to accurately get the correct size.

  3. Use the chart below to compare your measured value to the nearest size in the chart. If your measured value is in between two sizes, it is advisable to get the larger size.

 

Using a String

  1. You can use any string such as yarn, floss, twine, etc. or cut a strip of non-stretchy paper and wrap it around the base of the finger where your DoubleAccent ring will be placed.

  2. Wrap the paper comfortably on your finger; Make sure it’s not too tight or not too loose.

  3. Mark the part where the end of the string meets and completes the circle.

  4. Measure the length of the marked part in inches or cm and compare it to our size chart below.

  5. If your measured value is in between two sizes, it is advisable to get the larger size.

 

Please be advised that DoubleAccent is not liable for any errors that will occur in measuring ring sizes.